Discover the Grow1 Drain Fitting 1 / 2" Tub Outlet (10 / pk)
1 / 2" fill/drain fitting. This is the fitting that is commonly used to transfer nutrient solution between the flood table and the reservoir in flood & drain hydroponic systems via 1 / 2" tubing and a pump.
1. Always install bulkheads clean and dry, no silicone, teflon or thread lubricants. Silicone and lubricants cause the gasket to scoot out or not seal properly.
2. Before installing the bulkhead take a few minutes using a jewelers file, nail file or pocket knife and clean any excess flashing off both the male and female threads and from the flat gasket mating surfaces of the flange and nut. This is a common source of leaks.
3. Always install the gasket on the flange side of the bulkhead, never on the nut side, regardless if its inside or outside the tank. Installing the gasket next to the nut will lead to leaks as water travels along the threads around the gasket. Hand tighten only with maybe 1/4 to 1/2 turn additional, no more.
11" W x 3" H x 7" L
Weight: 0.9 lb
After your purchase, the items are subject to the respective manufacturer’s warranty policy.
These policies can be found on the original manufacturer’s website or by contacting them.
Indoor Growing Canada is not responsible for replacing, repairing or any costs associated with your item while under warranty.
Indoor Growing Canada will assist you in your warranty claim by helping you coordinate with the original manufacturer.